F5 301a Exam Dumps [2023] Practice Valid Exam Dumps Question
301a Dumps - Grab Out For [NEW-2023] F5 Exam
NEW QUESTION # 17
An TLM Specialist has an Exchange that must use the LTM device to route traffic to the internet.
Which SNAT/NAT configure allows the Exchange server's traffic access the internet through the LTM device?
- A. SNAT List
- B. SNAT Pool
- C. SNAT Automap
- D. NAT
Answer: A
NEW QUESTION # 18
Refer to the exhibit.
The http monitor is applied to a pool. All members are enabled. One server responds as follows.
What is the resulting status of this poo! member?
- A. Offline (Disabled)
- B. Offline (Enabled)
- C. Available (Enabled)
- D. Unavailable (Disabled)
Answer: B
Explanation:
The first picture "Send String" and "Receive String" are not clear. Send String should be "GOOD", the response packet does not contain this keyword. Receive Disable String is completely unclear. If the response packet contains the content of Receive Disable String at this time, it will be Available (Disabled), If the content of Receive Disable String is not included, then Offline (Enabled).
NEW QUESTION # 19
An LTM specialist needs to create a new account with the admin role called "newadmin' and access to all partitions.
Which tmsh command should be executed?
- A. create /users newadmin partition-access add {all-partitions {role admin JJ prompt for-password.
- B. create /user newadmin partition-access add (all-partitions {role admin }} prompt- for-password.
- C. create /auth user newadmin partition-access add {all-partitions {role admin }} prompt for-password.
- D. create / sys user newadmin partition-access add (all-partitions {role admin )} prompt-for-password.
Answer: C
Explanation:
Examining the use of commands, the creation of user is subordinate to auth
NEW QUESTION # 20
Refer to the exhibit.
A pool is contoured with four members. A user has a current connection established with 10.18.1.40. The virtual server has a persistence Profile configured.
- A. 10.18.1.40
- B. 10.18.1.20
- C. 10.18.1.10
- D. 10.18.1.30
Answer: A
NEW QUESTION # 21
One LTM device in an HA pair of LTM devices is unable to reach its default gateway. An HA Failover event needs to happen.
Which configuration item enables this behavior?
- A. Gateway pool
- B. Gateway pool monitor
- C. Gateway Fail Safe
- D. iRule
Answer: C
NEW QUESTION # 22
An TLM Specialist needs to configure a virtual server to terminate SSL connection on the LTM device.
Cryptographic information must be re-authorized for SSL sessions that remain open for longer than 30 seconds.
Which settings should the LTM Specialist configure in the client SSL profile?
- A. set the Handshake Timeout to 30 seconds
- B. set the Renegotiate Max Record Delay to 30
- C. enable Require Peer SN1 Support
- D. set the Renegotiate Period to 30 seconds
Answer: D
NEW QUESTION # 23
A design requires the LTM device to become HA standby when the one of the two physical interface on the External trunk is down the External trunk is an interface on the External VLAN Which TMOS command enables this behavior?
- A. tmsh create sys ha-group External trunks add External threshold 2 weight 101)
- B. tmsh modify net van External failsafe enabled
- C. tmsh create sys ha-group External trunks add ( External( attribute percent up-members 100))
- D. tmsh create sys ha-group External trunks add Externally
Answer: A
NEW QUESTION # 24
An LTM Specialist is configuring a client profile to offload processing a new application Company policy requires that clients can resume session for up to 30 minutes, but must renegotiate a new session after that.
Which setting should the LTM Specialist change to satisfy this requirement?
- A. Cache size
- B. Renegotiate Max Record Delay
- C. Cache timeout
- D. Renegotiation period
Answer: C
Explanation:
Question stem requires that you can resume SSL session within 30 minutes, then you need to define the ssl cache time in 30 minutes
NEW QUESTION # 25
An LTM specialist needs to upgrade a VCMP quest in an HA Setup with minimum interruption for all VCMP guest instances.
In which should the LTM Specialist perform this upgrade?
- A. Failover this specific guest's active traffic-group to the other Host, Relicense the guest, copy image to guest , create guest UCS, install and set boot location to new volume, reboot
- B. Failover all guests' active traffic-group to the other Host, Relicense the host, copy image to guest, create guest UCS, install and set boot location to new volume , reboot
- C. Failover all guests' active traffic-group to the other host, copy image to guest, create guest UCS install and set boot location to new volume, reboot, Relicense the host
- D. Relicense the host. Failover all guest's active traffic-groups to the other host, copy image to gest, create guest UCS install and set boot location to new volume, reboot
Answer: B
Explanation:
Switch guest, reactive, license first and then upgrade.
NEW QUESTION # 26
AN LTM Specialist is using an external monitor evaluate the hard drive usage of a node. The monitor has marked the node down because it exceeded the specific threshold. The disk usage on the server has been corrected below the threshold, however, the node remains offline.
Which feature is causing this problem?
- A. The value for UP interval is enable with a value greater than 0
- B. The parameter Time Until UP has a value greater than 0
- C. The value of Manual Resume is set to No
- D. The value for Manual Resume is set to Yes
Answer: D
NEW QUESTION # 27
An LTM Specialist plans to enable connection mirroring for a virtual server in an HA environment.
What must the LTM Specialist consider before implementing the configuration change?
- A. Decreased number of possible concurrent connections to that virtual server
- B. Creating the required separate interface for connection mirroring
- C. Impact on system performance that might be noticeable
- D. The add-on license that is required for this feature to be available
Answer: C
Explanation:
Connection mirroring will bring performance consumption
NEW QUESTION # 28
An application is being load balanced through the LTM device using the configuration displayed below.
The network has been re-engineered to NAT all client connection. As a result, all client connections are hitting the same pool member.
Which changes should the LTM Specialist make in order to restore load balancing functionality wile maintaining session persistence?
- A. Change the virtual serer type to Forwarding (Layer 4) and leave the persistence type to hash source Address
- B. Leave the virtual server type set Performance (Layer 4) and change the persistence type to hash
- C. Change the virtual server type to Standard, add an http profile, and change the persistence profile to Destination Address
- D. Change the virtual server to Standard add an http profile, and change the persistence profile to Cookie persistence
Answer: D
NEW QUESTION # 29
Refer to the exhibit.
An LTM Specialist configures the two syslog destination Syslog destination #1 can receive messages but the syslog destination #2 can NOT receive messages.
Which command sill correct the issue?
- A. {/Common)(tmos) # modify Ays syslog remote servers modify {syslog_dest2 {local- ip 10.208.102 254)}
- B. {/Common)(tmos) # modify /syssyslog remote-servers modify (syslog_dest2 {local-ip
- C. {/Common) (tmos) # modify /sys syslog remote-servers modify {syslog_dest2 {host 10 208.102.254 }}
- D. {Common(tmos) # modify/syslog remote-servers modify {syslog_dest2 {lost.10.10.10.28 }}
Answer: B
NEW QUESTION # 30
An LTM device configuration is as shown:
An LTM device configuration is as shown
What should be the two expected outcomes based on this configuration? (Choose two.)
- A. A client session that has been idle for 16 minutes will be sent to the same pool member
- B. A client session that has been idle for 12 minutes will be sent to the same pool member
- C. A client session that has been idle for 20 minutes will be balanced to a new pool member
- D. A client session that has been idle for 48 minutes will be sent to the same pool members
- E. A client session that has been idle for 14 minutes will be balanced to a new pool member
Answer: B,C
NEW QUESTION # 31
An LTM device an application that requires all connections to be secured via SSL The device must verify that request contain a specific cookie before allowing the request to be sent to the pool member.
Which virtual server type should an LTM Specialist configure on the LTM device?
- A. Stateless
- B. Forwarding (IP)
- C. Standard
- D. Performance (HTTP)
- E. Performance (Layer 4)
Answer: C
NEW QUESTION # 32
......
The F5 301a exam is a highly respected certification in the IT industry, and is recognized by many organizations as a valuable credential for IT professionals who specialize in F5 BIG-IP LTM technology. Earning this certification can open up new career opportunities and help IT professionals advance their careers. Additionally, this certification can help organizations ensure that their IT staff have the skills and knowledge needed to effectively manage and maintain their F5 BIG-IP LTM deployments.
301a Exam Dumps PDF Guaranteed Success with Accurate & Updated Questions: https://www.dumpstorrent.com/301a-exam-dumps-torrent.html
Pass 301a Exam - Real Test Engine PDF with 150 Questions: https://drive.google.com/open?id=1NHWqcp0zbS-kaXy8trg3iljiLbO6SFJH