DEA-5TT2 Dumps 2024 - New EMC DEA-5TT2 Exam Questions
Free DEA-5TT2 Braindumps Download Updated on Jan 26, 2024 with 62 Questions
NEW QUESTION # 26
Which component translates data, signaling, and protocols to facilitate the data flow between the end device and the network?
- A. Transceiver
- B. NIC
- C. Switch
- D. Port
Answer: A
NEW QUESTION # 27
Which route type is added to the routing table by a routing protocol?
- A. Dynamic
- B. Static
- C. Default route
- D. Directly connected
Answer: A
NEW QUESTION # 28
Which topology is considered a best practice when stacking switches?
- A. Cascade
- B. Ring
- C. Serial
- D. Daisy-chain
Answer: B
NEW QUESTION # 29
A network administrator has a stack of four Dell EMC Networking S4800 Series switches. Each stack unit is configured with a different priority. Which switch will be elected as the management device?
- A. Switch with priority 1
- B. Switch with priority 0
- C. Switch with priority 21
- D. Switch with priority 14
Answer: A
NEW QUESTION # 30
A network administrator created three VLANs on an Ethernet switch. How many broadcast domains are created by the switch?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: B
NEW QUESTION # 31
An Ethernet switch receives a frame from a directly connected host. The source MAC address of the frame is not present in the MAC address table for the switch. However, the destination address is present in the MAC address table.
What does the switch do with the frame?
- A. Adds the source MAC address and port to the MAC address table and forwards the frame.
- B. Floods the frame to all ports except for the port the frame originated from to locate the source MAC address.
- C. Flushes the destination MAC address and updates the MAC address table in the switch.
- D. Discards the frame on all ports and sends an error message back to the host.
Answer: A
NEW QUESTION # 32
On Switch A, a static route has been redistributed into OSPF. Which type of OSPF router will this process make Switch A?
- A. Backbone Router (BR)
- B. Autonomous System Boundary Router (ASBR)
- C. Designated router (DR)
- D. Area Border Router (ABR)
Answer: B
NEW QUESTION # 33
Which IPv6 scope is used for private addressing on a local network?
- A. Unique local
- B. Global
- C. APIPA
- D. Area wide
Answer: A
NEW QUESTION # 34
Which port type should be used for only VLAN-unaware devices?
- A. Trunk port
- B. Hybrid port
- C. General port
- D. Access port
Answer: B
NEW QUESTION # 35
On which Dell EMC Networking switches can Multi-Chassis Link Aggregation (MLAG) be configured?
- A. C9000 Series
- B. N-Series
- C. Z-Series
- D. S-Series
Answer: B
NEW QUESTION # 36
How many total addresses for network, broadcast, and host are provided with the subnet mask
255.255.255.240?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION # 37
You recently joined a company as a junior-level network administrator. You have been tasked with designing the IPv4 scheme for five networks that will be used for training classrooms. These networks need to support no more than 28 devices each. Due to the existing network design, the senior-level network administrator has asked you to work on network 192.168.40.0/24.
If all networks must be made to logically start with the lowest numbered network and end with the largest numbered network, what is the network ID for the third network?
- A. 192.168.40.128/27
- B. 192.168.40.32/27
- C. 192.168.40.64/27
- D. 192.168.40.96/27
Answer: C
NEW QUESTION # 38
A Dell EMC Networking N-Series switch is configured on a port channel with LACP using the interfaces Te1/0/1 and Te1/0/2. How is the egress traffic distributed among the interfaces?
- A. Traffic overflow will be sent to the second interface
- B. Interfaces will be used in active/passive
- C. Load balanced per packet using round robin
- D. Load balanced using a hash function
Answer: D
NEW QUESTION # 39
Which platforms are supported by the Dell EMC Networking OS (DNOS) 6?
- A. N1500 Series switch and N2000 Series switch
- B. N1700 Series switch and N1500 Series switch
- C. N1700 Series switch and N3500 Series switch
- D. N3500 Series switch and N2000 Series switch
Answer: A
NEW QUESTION # 40
Which flags are used in the TCP header to initiate and end TCP connections or sessions?
- A. Initiate = Acknowledge (ACK) End = Synchronize (SYN)
- B. Initiate = Acknowledge (ACK) End = Finish (FIN)
- C. Initiate = Finish (FIN) End = Synchronize (SYN)
- D. Initiate = Synchronize (SYN) End = Finish (FIN)
Answer: D
NEW QUESTION # 41
What is the default route preference value for a Border Gateway Protocol (BGP) internal route?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION # 42
What is the bandwidth of an RPM for a C9010 Network Director?
- A. 1.52 Tbps
- B. 2.56 Mbps
- C. 2.56 Tbps
- D. 200 Mbps
Answer: C
NEW QUESTION # 43
......
EMC DEA-5TT2 Exam Practice Test Questions: https://www.dumpstorrent.com/DEA-5TT2-exam-dumps-torrent.html
Updated Certification Exam DEA-5TT2 Dumps - Practice Test Questions: https://drive.google.com/open?id=1MhWhLTJ8rItCPGhFZexFt5LvB6PbSuTb